Firmware rejects rxdelay outside 0-20 and txdelay/direct.txdelay outside
0-2.0; the CLI only rejected negatives, so a remote admin could set
delay factors far beyond what any firmware node would accept. Apply the
firmware ranges with the firmware error strings and state the ranges in
the help text. Existing configs with out-of-range values are untouched —
only new CLI sets are gated. Also adds an end-to-end regression test
running every set command against the real ConfigManager on a temp
config file.
set flood.advert.interval wrote flood_advert_interval_hours, a key
nothing reads, and get reported it with a default of 24 — the engine's
flood-advert timer (and the web API) consume send_advert_interval_hours
with a default of 10. Read and write the consumed key so the remote
command actually reschedules the timer; the orphan key is left in place
and ignored.
set freq and set radio stored the CLI's MHz/kHz inputs directly into
radio.frequency and radio.bandwidth, which the rest of the stack treats
as Hz — a freq change tuned the radio to a few hundred hertz. Convert to
Hz on write and validate set radio with the firmware gate (freq 150-2500,
bw 7-500, sf 5-12, cr 5-8, same error string; set freq stays unvalidated
like firmware). Radio changes are now saved without a live apply so the
reply's restart-to-apply contract is real: a live retune would cut off
the remote admin mid-session, and the all-or-nothing live radio path
would also have dragged staged frequency changes along with a tx tweak.
The password, guest.password, and allow.read.only commands wrote a
top-level security section with a stale key name, while LoginHelper
authenticates from repeater.security.admin_password/.guest_password/
.allow_read_only — so remote password changes never took effect. Point
the set and get commands at the real subtree, and push repeater.security
onto the live repeater ACL during a repeater-section live update: the
ACL captures its passwords at registration, so without the refresh a
saved change would still only apply after a restart. Room-server ACLs
keep their per-identity settings passwords.
ConfigManager.save_to_file returns a bare bool, but every mesh CLI set
command (and the password command) still tuple-unpacked it, so each one
wrote the YAML and then raised, skipping the live update and returning an
error to the remote admin. Route every save through one helper that
checks the bool, reports save failures honestly, and only live-applies
after a successful write. The test fixture mocked the stale tuple shape,
which is why the suite stayed green while the CLI was broken on the real
manager.
The mesh CLI's get/set txdelay and direct.txdelay read and wrote
repeater.tx_delay_factor / repeater.direct_tx_delay_factor, but the
engine and web API use the delays section, so the CLI knobs were
silently dead: set appeared to succeed while changing nothing, and get
echoed the unused value back. Same defect and same fix as the recent
rxdelay repoint.
standardize default region on mesh.default_region (remove legacy region_default_scope usage)
add/align CLI support for owner.info, path.hash.mode, and loop.detect with validation
wire UI terminal get/set + autocomplete/help for owner.info, path.hash.mode, loop.detect
extend update_radio_config to persist owner_info for UI set owner.info
add and use shared packet utility for advert creation + default-region transport scoping
refactor repeater and room-server advert paths to reuse shared packet logic
- Updated byte representations in tests to use lowercase hex format for consistency.
- Reformatted code for better readability, including line breaks and indentation adjustments.
- Consolidated multiple lines into single lines where appropriate to enhance clarity.
- Ensured that all test cases maintain consistent formatting and style across the test suite.
agessaman